Separate the light control ECU socket as shown in the illustration.
Release the set spring and remove the discharge headlight bulb as shown in the illustration.
8.
REMOVE FRONT TURN SIGNAL LIGHT BULB
Turn the front turn signal light bulb and front turn signal light socket in the direction indicated by the arrow shown in the illustration, and remove them as a unit.
Remove the front turn signal light bulb from the front turn signal light socket.
9.
REMOVE CLEARANCE LIGHT BULB
Turn the clearance light bulb and clearance light socket in the direction indicated by the arrow shown in the illustration, and remove them as a unit.
Remove the clearance light bulb from the clearance light socket.
10.
REMOVE LIGHT CONTROL ECU SUB-ASSEMBLY (for HID Headlight)
Remove the 4 screws.
Disconnect the connector and remove the light control ECU sub-assembly.
11.
REMOVE HEADLIGHT GASKET (for HID Headlight)
Remove the headlight gasket.
NOTICE:
After the headlight gasket is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.
12.
REMOVE HEADLIGHT LEVELING MOTOR (for HID Headlight)
Align the notches of the headlight leveling motor and housing, and pull out the headlight leveling motor slightly.
Lower the tip of the headlight leveling motor to disengage it from the reflector and remove the headlight leveling motor.
13.
REMOVE HEADLIGHT LEVELING MOTOR BASE PACKING (for HID Headlight)
Remove the headlight leveling motor base packing.
NOTICE:
After the headlight leveling motor base packing is removed, be sure to replace it with a new one. Failure to do this may cause water ingress.