INSTALLATION
Removal / installation · Vehicles built from Jun 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
INSTALL CLUTCH SWITCH ASSEMBLY |
 |
Fully loosen the lock nut of the clutch switch assembly.
Adjust the clutch switch until the threaded portion makes gentle contact with the cushion.
- Tighten the lock nut and verify the contact of the switch threaded portion with the cushion.
-
Torque:
- 15.7 N*m{
160 kgf*cm
, 12 ft.*lbf
}
Connect the connector.
| 2.
INSTALL MAIN BODY ECU (INSTRUMENT PANEL JUNCTION BLOCK) (for LHD) |
 |
- Install the main body ECU (instrument panel junction block) with the 2 nuts.
-
Torque:
- 8.0 N*m{
82 kgf*cm
, 71 in.*lbf
}
Connect all connectors.
| 3.
INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL (for LHD)
|
 |
- Install the air hose and connect the connector.
Engage the 2 claws and the DLC3.
Engage the claw and the 4 clips.
Install the lower No. 1 instrument panel finish panel with the screw <B> and bolt <A>.
| 4.
INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH (for LHD)
|
 |
- Engage the 2 clips.
Install the cowl side trim sub-assembly LH with the cowl side trim clip.
| 5.
INSTALL FRONT DOOR SCUFF PLATE LH (for LHD)
|
 |
- Engage the 7 claws and 3 clips, then install the front door scuff plate LH.
| 6.
INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL (for RHD)
|
 |
- Install the air hose and connect each connector.
Engage the claw and the 4 clips.
Engage the 2 claws and the DLC3.
Install the lower No. 1 instrument panel finish panel with the screw <F> and bolt <D>.
| 7.
INSTALL COWL SIDE TRIM SUB-ASSEMBLY RH (for RHD)
|
 |
- HINT:
- Use the same procedure for the RH side and the LH side.
| 8.
INSTALL FRONT DOOR SCUFF PLATE RH (for RHD)
|
 |
- HINT:
- Use the same procedure for the RH side and the LH side.