2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Headlight Cleaner Motor and Relay Circuit

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

This circuit provides power to the headlight cleaner control relay.
The headlight cleaner control relay receives the signal from the switch, etc., to operate the headlight cleaner motor and pump.

WIRING DIAGRAM

E138730E01

INSPECTION PROCEDURE


1. INSPECT FUSE (ECU IG NO. 2)
  1. Remove the ECU IG No. 2 fuse from the instrument panel J/B.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. INSPECT HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY

  1. I004068E02
    Disconnect the A38 headlight cleaner motor and pump assembly connector.

  1. Connect the positive (+) battery lead to terminal A38-1 of the headlight cleaner motor and pump assembly, and the negative (-) battery lead to terminal A38-2.

    OK:
    Operation sounds are heard.



NG
REPLACE HEADLIGHT CLEANER MOTOR AND PUMP ASSEMBLY
OK


3. CHECK HARNESS AND CONNECTOR (HEADLIGHT CLEANER MOTOR CIRCUIT)

  1. E125073E08
    Connect the A38 headlight cleaner motor and pump assembly connector.

  1. Disconnect the A39 headlight cleaner control relay connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    A39-3 (IG) - Body ground
    Engine switch on (IG)
    10 to 14 V
    A39-6 (PB) - Body ground
    Always
    10 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A39-4 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (HEADLIGHT CLEANER CONTROL RELAY - BATTERY)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Headlight Cleaner Switch Circuit (from Oct 2006)Washer Motor Circuit (from Oct 2006) →