2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Rain Sensor Circuit

Circuit diagnosis · Vehicles built from Jun 2006

DESCRIPTION

This circuit provides power to operate the rain sensor.
The auto wiper system operates when the windshield wiper switch assembly is in the AUTO position.

WIRING DIAGRAM

B129039E06

INSPECTION PROCEDURE


1. CHECK HARNESS AND CONNECTOR (WIPER RELAY - RAIN SENSOR)

  1. E125076E04
    Disconnect the E26 windshield wiper relay assembly (auto wiper relay) connector.

  1. Disconnect the Q4 rain sensor connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E26-8 (SIG) - Q4-4 (SIG)
    Always
    Below 1 Ω
    E26-14 (PA1) - Q4-3 (AUTO)
    Always
    Below 1 Ω
    E26-25 (E) - Q4-1 (ES)
    Always
    Below 1 Ω
    Q4-4 (SIG) - Body ground
    Always
    10 kΩ or higher
    Q4-3 (AUTO) - Body ground
    Always
    10 kΩ or higher
    Q4-1 (ES) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Wiper and Washer Switch Circuit (from Jun 2009)Washer Motor Circuit (from Jun 2006) →