Rain Sensor Circuit
Circuit diagnosis · Vehicles built from Oct 2006
DESCRIPTION
This circuit provides power to operate the rain sensor.The auto wiper system operates when the windshield wiper switch assembly is in the AUTO position.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (WIPER RELAY - RAIN SENSOR) |
Disconnect the E26 windshield wiper relay assembly (auto wiper relay) connector.

Disconnect the Q4 rain sensor connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E26-8 (SIG) - Q4-4 (SIG)
Always
Below 1 Ω
E26-14 (PA1) - Q4-3 (AUTO)
Always
Below 1 Ω
E26-25 (E) - Q4-1 (ES)
Always
Below 1 Ω
Q4-4 (SIG) - Body ground
Always
10 kΩ or higher
Q4-3 (AUTO) - Body ground
Always
10 kΩ or higher
Q4-1 (ES) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
