Wiper Motor Power Source Circuit
Circuit diagnosis · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
This circuit provides power to the windshield wiper motor assembly.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. INSPECT FUSE (WIP) |
 |
Remove the WIP fuse from the instrument panel J/B.
Measure the resistance of the fuse.
- Standard resistance:
- Below 1 Ω
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 2. INSPECT IG1 RELAY |
 |
Remove the IG1 relay from the instrument panel J/B.
Measure the resistance of the relay.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
3 - 5
|
Always
|
10 kΩ or higher
|
When battery voltage is applied to terminals 1 and 2
|
Below 1 Ω
|
|
NG |
 |
|
|
|
| OK |
|
 |
|
| 3. CHECK HARNESS AND CONNECTOR (WIPER MOTOR - BATTERY, BODY GROUND) |
 |
- Disconnect the A59 windshield wiper motor assembly connector.
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Tester Connection
|
Condition
|
Specified Condition
|
A59-2 (B) - Body ground
|
Engine switch on (IG)
|
10 to 14 V
|
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
|
Condition
|
Specified Condition
|
A59-5 (E) - Body ground
|
Always
|
Below 1 Ω
|
|
NG |
 |
|
| REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
|
| OK |
|
 |
|
| PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE |
|