2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Wiper Motor Power Source Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009

DESCRIPTION

This circuit provides power to the windshield wiper motor assembly.

WIRING DIAGRAM

E194791E01

INSPECTION PROCEDURE


1. INSPECT FUSE (WIP)
  1. Remove the WIP fuse from the instrument panel J/B.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. INSPECT IG1 RELAY
B137115E02
  1. Remove the IG1 relay from the instrument panel J/B.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Always
    10 kΩ or higher
    When battery voltage is applied to terminals 1 and 2
    Below 1 Ω



NG
REPLACE IG1 RELAY
OK


3. CHECK HARNESS AND CONNECTOR (WIPER MOTOR - BATTERY, BODY GROUND)

  1. E112829E06
    Disconnect the A59 windshield wiper motor assembly connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    A59-2 (B) - Body ground
    Ignition switch ON
    10 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    A59-5 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Wiper Motor Power Source Circuit (Jun 2006 – May 2009)Wiper and Washer Switch Circuit (Jun 2006 – May 2009) →