2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

Center Airbag Sensor Communication Stop Mode

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

Detection Item
Symptom
Trouble Area
Center Airbag Sensor Communication Stop Mode
  1. "SRS Airbag" is not displayed on the "Communication Bus Check" screen of the intelligent tester
  2. Applies to "Center Airbag Sensor Communication Stop Mode" in the "DTC COMBINATION TABLE"
  1. Power source circuit of the center airbag sensor
  2. Center airbag sensor branch wire or connector
  3. Center airbag sensor assembly

WIRING DIAGRAM

C142794E03

INSPECTION PROCEDURE

NOTICE:
  1. Turn the ignition switch off before measuring the resistance of the CAN main wire and CAN branch wires.
  2. After the ignition switch is turned off, check that the key reminder warning system and lighting system are not operating.
  3. Before measuring the resistance, leave the vehicle as is for at least 1 minute and do not operate the ignition switch, any other switches or the doors. If doors need to be opened in order to check connectors, open the doors and leave them open.

HINT:
Operating the engine switch, any other switches, or any doors triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.


1. CHECK OPEN IN CAN BUS WIRE (CENTER AIRBAG SENSOR BRANCH WIRE)
  1. Turn the ignition switch off.

  1. Disconnect the center airbag sensor connector.

  1. C104732E06
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    E30-13 (CANH) - E30-22 (CANL)
    Ignition switch off
    54 to 69 Ω



NG
REPAIR OR REPLACE CENTER AIRBAG SENSOR BRANCH WIRE OR CONNECTOR
OK


2. CHECK WIRE HARNESS (IG2, E1, E2)

  1. C104732E07
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Value
    E30-25 (E1) - Body ground
    Always
    Below 1 Ω
    E30-26 (E2) - Body ground
    Always
    Below 1 Ω

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Value
    E30-21 (IG2) - Body ground
    Ignition switch on
    10 to 14 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CENTER AIRBAG SENSOR ASSEMBLY


← Combination Meter ECU Communication Stop Mode (from Oct 2006)Navigation ECU Communication Stop Mode (from Jun 2009) →