2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

INSTALLATION

Removal / installation · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL STOP LIGHT SWITCH ASSEMBLY

  1. C133308
    Insert the stop light switch until the body hits the cushion.

    NOTICE:
    When inserting the stop light switch, support the pedal from behind so that the pedal is not pushed in.

  1. C131701E02
    Make a quarter turn clockwise to install the stop light switch.

    Torque:
    1.5 N*m{ 15 kgf*cm , 13 in.*lbf } or less

    NOTICE:
    When inserting the stop light switch, support the pedal from behind so that the pedal is not pushed in.

  1. C133309E01
    Connect the stop light switch connector.

  1. Check the protrusion of the rod (Click here).


2. INSTALL COMBINATION METER ASSEMBLY
  1. Connect the connector.

  1. E136755
    Install the combination meter assembly as shown in the illustration.

  1. E136754
    Install the 4 screws.


3. INSTALL INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

  1. E128011E01
    Engage the guide and the 4 claws.

  1. Install the instrument cluster finish panel sub-assembly with the 2 clips.


4. INSTALL LOWER INSTRUMENT PANEL FINISH PANEL

  1. B144612
    Engage the 2 claws and 2 clips to install the lower instrument panel finish panel.


5. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (for LHD)
  1. Connect each connector.

  1. B149938
    Engage the 3 claws and 2 clips to install the No. 1 instrument panel sub-assembly.


6. INSTALL NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (for RHD)
  1. Connect each connector.

  1. B149936
    Engage the 3 claws and 2 clips to install the No. 1 instrument panel sub-assembly.


7. INSTALL LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
  1. Install the air hose and connect the connector.

  1. B147264
    Engage the claw and the 4 clips.

  1. Connect the hood lock control cable assembly.

  1. Engage the 2 claws and connect the connector.

  1. Install the lower No. 1 instrument panel finish panel with the screw and bolt.


8. INSTALL COWL SIDE TRIM SUB-ASSEMBLY LH

  1. B132116E01
    Engage the 2 clips.

  1. Install the cowl side trim sub-assembly LH with the cowl side trim clip.


9. INSTALL FRONT DOOR SCUFF PLATE LH

  1. B132067
    Engage the 7 claws and 3 clips, then install the front door scuff plate LH.

← INSPECTION (from Jun 2009)INSTALLATION (Oct 2006 – May 2009) →