2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.


1. REMOVE FRONT DOOR SCUFF PLATE LH

  1. B132067
    Disengage the 7 claws and 3 clips, and remove the front door scuff plate LH.


2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH

  1. B132116E01
    Remove the cowl side trim clip.

  1. Disengage the 2 clips and remove the cowl side trim sub-assembly LH.


3. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL LH

  1. B147264E01
    Remove the bolt <A> and the screw <B>.

  1. Disengage the 2 claws and the DLC3.

  1. Disconnect the hood lock control cable assembly.

  1. Disengage the claw and the 4 clips.

  1. Remove the air hose, disconnect the connector, and then remove the lower No. 1 instrument panel finish panel.


4. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (for LHD)

  1. B149938
    Disengage the 3 claws and the 2 clips.

  1. Disconnect each connector and remove the No. 1 instrument panel sub-assembly.


5. REMOVE NO. 1 INSTRUMENT PANEL SUB-ASSEMBLY (for RHD)

  1. B149936
    Disengage the 3 claws and the 2 clips.

  1. Disconnect the connector and remove the No. 1 instrument panel sub-assembly.


6. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Smart Entry and Start System)

  1. B144612
    Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.


7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/ Smart Entry and Start System)

  1. B159330
    Disengage the 2 claws and 2 clips, and then remove the lower instrument panel finish panel.

  1. Disconnect the connector.


8. REMOVE INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY

  1. B133985E01
    Remove the 2 clips.

  1. Disengage the guide and 4 claws, and then remove the instrument cluster finish panel sub-assembly.


9. REMOVE COMBINATION METER ASSEMBLY

  1. B152781E01
    Remove the 4 screws <E>.

  1. Disconnect each connector and remove the combination meter assembly.


10. REMOVE STOP LIGHT SWITCH

  1. C133309E01
    Disconnect the stop light switch connector.

  1. C133307
    Turn the stop light switch counterclockwise and remove the stop light switch.

← REMOVAL (Jun 2006 – Sep 2006)REMOVAL (from Jun 2009) →