2006-2011 Camry Aurion · Service Manual ENGINE

INSTALLATION

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. INSTALL REAR EXHAUST PIPE NO. 1 SUPPORT BRACKET

  1. A060823E05
    Install the rear support bracket with the 2 bolts.

    Torque:
    33 N*m{ 337 kgf*cm , 24 ft.*lbf }

    NOTICE:
    Be sure to install the bracket in the correct direction.


2. INSTALL HEATED OXYGEN SENSOR
  1. Temporarily tighten the heated oxygen sensor.

    NOTICE:
    Do not damage the heated oxygen sensor.

  1. A146290E01
    Using SST, fully tighten the heated oxygen sensor.
    SST
    09224-00010  

    Torque:
    44 N*m{ 449 kgf*cm , 32 ft.*lbf }

    NOTICE:
    The torque shown above should be used for tightening without using SST. When the SST is used for tightening, the torque should be calculated based on the length of the SST (Click here).

  1. A146034
    Connect the heated oxygen sensor connector.


3. INSTALL FRONT EXHAUST PIPE ASSEMBLY
  1. Install a new gasket onto the front exhaust pipe assembly.

  1. Install the front exhaust pipe assembly with the 2 nuts.

    Torque:
    62 N*m{ 632 kgf*cm , 46 ft.*lbf }


    A146050

  1. Install the front exhaust pipe No. 1 support bracket with the 2 nuts.

    Torque:
    33 N*m{ 337 kgf*cm , 24 ft.*lbf }


4. INSTALL CENTER EXHAUST PIPE ASSEMBLY
  1. Install a new gasket onto the front exhaust pipe.

  1. Install the center exhaust pipe assembly with the 2 bolts and 2 nuts.

    A146049

    Torque:
    56 N*m{ 571 kgf*cm , 41 ft.*lbf }


5. INSTALL TAIL PIPE ASSEMBLY
  1. Install a new gasket onto the center exhaust pipe assembly.

  1. Install the tail pipe assembly with the 2 nuts.

    A146048

    Torque:
    43 N*m{ 438 kgf*cm , 32 ft.*lbf }


6. CHECK FOR EXHAUST GAS LEAKS
If gas is leaking, tighten the areas necessary to stop the leak. Replace the damaged parts as necessary.
← INSTALLATION (Oct 2006 – May 2009)COMPONENTS (from Oct 2006) →