2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Power Source Circuit

Circuit diagnosis · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

This circuit provides power to the windshield wiper relay assembly (auto wiper relay).

WIRING DIAGRAM

E138727E01

INSPECTION PROCEDURE


1. INSPECT FUSE (WIP)
  1. Remove the WIP fuse from the instrument panel J/B.

  1. Measure the resistance of the fuse.

    Standard resistance:
    Below 1 Ω



NG
REPLACE FUSE
OK


2. INSPECT IG1 RELAY

  1. B137115E02
    Remove the IG1 relay from the instrument panel J/B.

  1. Measure the resistance of the relay.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3 - 5
    Always
    10 kΩ or higher
    When battery voltage is applied to terminals 1 and 2
    Below 1 Ω



NG
REPLACE IG1 RELAY
OK


3. CHECK HARNESS AND CONNECTOR (WIPER RELAY - BATTERY, BODY GROUND)

  1. B122460E12
    Disconnect the E26 windshield wiper relay assembly (auto wiper relay) connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Condition
    Specified Condition
    E26-12 (IG) - Body ground
    Engine switch on (IG)
    10 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E26-26 (E) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE


← Speed Signal Circuit (from Jun 2009)Power Source Circuit (from Jun 2009) →