2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

Open in One Side of CAN Branch Line

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

If some ECUs and sensors are not displayed on the "Communication Bus Check" screen of the intelligent tester and some ECUs and sensors repeatedly appear and disappear from the screen when the CAN main bus wires are normal (there is no open, short, short to B+, or short to GND in the main bus wires), there may be an open circuit in either of the CAN branch wires.

HINT:
If some ECUs and sensors repeatedly appear and disappear from the "Communication Bus Check" screen, communication between the normal ECUs (sensors) and intelligent tester may be affected by the incomplete signals that are output from the ECU that has an open circuit in either of its CAN branch wires. In this case, the CAN branch wires for the ECUs and sensors that repeatedly appear and disappear from the screen are normal and the ECU that is not displayed on the screen may be the main cause of the problem (this ECU may have an open circuit in either of its CAN branch wires).

Symptom
Trouble Area
2 or more ECUs and/or sensors do not appear on the intelligent tester "BUS CHECK" screen.
One side of the CAN branch wire is open
  1. Skid control ECU
  1. Steering angle sensor
  1. Yaw rate sensor
  1. ECM
  1. Combination meter
  1. A/C amplifier
  1. ACM ECU
  1. Main Body ECU
  1. Gateway ECU
  1. Center airbag sensor

WIRING DIAGRAM

C212182E02
C212183E03

INSPECTION PROCEDURE


1. CHECK FOR OPEN IN ONE SIDE OF CAN NO. 1 BUS BRANCH WIRE
  1. Confirm the systems (ECUs and sensors), which use CAN communication, equipped on the vehicle. (Click here)

  1. Using the intelligent tester, select and perform "Communication Bus Check". (Click here)

  1. Observe the screen for approximately 1 minute to check the ECUs and sensors that are not displayed on the screen and also those that repeatedly appear and disappear from the screen.

  1. Disconnect the branch wire connectors, which are connected to the ECUs or sensors that are not displayed on the screen, from the CAN J/C.C212178E01
    C152831E01

    CAN No. 1 J/C connectors ("A" side, with earth terminal)
    Connector Color
    Color (CAN-H Side)
    Color (CAN-L Side)
    CAN Main / Bus wire (E42)
    White
    B
    W
    Center Airbag Sensor (E45)
    Black
    B
    W
    CAN No. 1 J/C connectors ("B" side, with earth terminal)
    Connector Color
    Color (CAN-H Side)
    Color (CAN-L Side)
    Yaw Rate Sensor (E46)
    Blue
    B
    W
    DLC3 (E62)
    Gray
    B
    W
    Steering Angle Sensor (E63)
    Brown
    B
    W
    Combination Meter (E43)
    White
    B
    W
    Main Body ECU (E44)
    Black
    B
    W
    C137762E08
    Terminals
    Wiring Color
    Connects to
    A40-1 (CANH)
    B
    ECM (CANH)
    A40-7 (CANL)
    W
    ECM (CANL)
    A40-2 (CANH)
    B
    Skid Control ECU (CANH)
    A40-8 (CANL)
    W
    Skid Control ECU (CANL)
    C137763E49
    Terminals
    Wiring Color
    Connects to
    E41-1 (CANH)
    B
    A/C Amplifier (CANH)
    E41-7 (CANL)
    W
    A/C Amplifier (CANL)
    E41-2 (CANH)
    B
    Gateway ECU (CANH)
    E41-8 (CANL)
    W
    Gateway ECU (CANL)
    E41-4 (CANH)
    B
    CAN No. 2 J/C (CANH)
    E41-10 (CANL)
    W
    CAN No. 2 J/C (CANL)

    HINT:
    1. Connecting locations of the connectors shown in the above tables are those of a vehicle whose connector locations have never been changed.
    2. If the connector locations differ from those shown in the above tables, identify each connector according to the color of the bus wires.

  1. Check that the ECUs and sensors, which repeatedly appeared and disappeared from the "Communication Bus Check" screen, are constantly displayed.

  1. Perform the communication stop mode check for the ECUs and sensors which correspond to the disconnected branch wire connectors.


NEXT

GO TO CORRESPONDING COMMUNICATION STOP MODE


← Open in One Side of CAN Branch Line (Oct 2006 – May 2009)PRECAUTION (Oct 2006 – May 2009) →