2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2006


INSPECT LICENSE PLATE LIGHT ASSEMBLY

  1. E119972E05
    Disconnect the connector from the license plate light assembly.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    LH Side:
    Tester Connection
    Condition
    Specified Condition
    S4-1 - S4-2
    Light control switch OFF → TAIL
    Below 1 V → 10 to 14 V
    RH Side:
    Tester Connection
    Condition
    Specified Condition
    S1-1 - S1-2
    Light control switch OFF → TAIL
    Below 1 V → 10 to 14 V

    If the result is not as specified, repair or replace the wire harness or connector.

← COMPONENTS (from Oct 2006)REMOVAL (Oct 2006 – May 2009) →