INSPECTION
Inspection · Vehicles built from Jun 2006
| INSPECT NO. 1 ROOM LIGHT ASSEMBLY (w/o Sliding Roof) |
Apply battery voltage to the No. 1 room light assembly connector.

Check that the interior light comes on.
- OK:
Measurement Condition
Switch Condition
Specified Condition
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 2
DOOR
Interior light comes on
Battery positive (+) → Terminal 1
Battery negative (-) → Terminal 3
ON
Interior light comes on
| INSPECT SPOT LIGHT ASSEMBLY (w/ Sliding Roof) |
Apply battery voltage to the spot light assembly connector.

Check that the rear personal light comes on.
- OK:
Measurement Condition
Switch Condition
Specified Condition
Battery positive (+) → Terminal Q10-2
Battery negative (-) → Terminal Q10-4
Pushed (ON)
Rear RH personal light comes on
Battery positive (+) → Terminal Q10-2
Battery negative (-) → Terminal Q10-3
Always
Rear RH personal light comes on
Battery positive (+) → Terminal Q11-2
Battery negative (-) → Terminal Q11-4
Pushed (ON)
Rear LH personal light comes on
Battery positive (+) → Terminal Q11-2
Battery negative (-) → Terminal Q11-5
Always
Rear LH personal light comes on
