B1242 Wireless Door Lock Tuner Circuit Malfunction
Diagnostic trouble codes · Vehicles built from Oct 2006
DESCRIPTION
- The electrical key antenna is used to receive electric waves relating to the entry functions of the smart entry and start system. The certification ECU decodes the requested smart entry and start system operation by identifying a key code based on electric waves received via the electrical key antenna and the door control receiver.
- The door control receiver receives a signal from the wireless door control transmitter and sends signals to the main body ECU through the certification ECU.
- The certification ECU then sends a command, according to the requested operation, to each ECU. (e.g. If door lock operation is requested, the ECU sends a door lock command to the main body ECU.)
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1242 |
The certification ECU detects that there is a short in the circuit between terminals RSSI, or between terminals DATA and RDA. |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - DOOR CONTROL RECEIVER) |
![]() ![]() |
Disconnect the E58 certification ECU connector and O18 door control receiver connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Symbol
(Tester Connection)
Condition
Specified Condition
RSSI (E58-39) - RSSI (O18-5)
Always
Below 1 Ω
RDA (E58-38) - DATA (O18-3)
Always
Below 1 Ω
RSSI (E58-39) - RDA (E58-38)
Always
10 kΩ or higher
RSSI (E58-39) - Body ground
Always
10 kΩ or higher
RDA (E58-38) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | |
| 2. INSPECT CERTIFICATION ECU |
![]() ![]() |
Reconnect the E58 ECU connector.
Measure the voltage according to the value(s) in the table below.
- Standard voltage:
Symbol
(Tester Connection)
Condition
Specified Condition
RSSI (E58-39) - E (E58-17)
Engine switch off, all doors closed, the electrical key is not in the actuation area
Below 1 V
Engine switch off, all doors closed, the electrical key is in the actuation area
4.6 to 5.4 V
RDA (E58-38) - E (E58-17)
Engine switch off, all doors closed and transmitter switch not pressed
10 to 14 V pulse generation at regular intervals
Engine switch off, all doors closed and transmitter switch pressed
Pulse generation
|
|
||||
| OK | |
| 3. REPLACE DOOR CONTROL RECEIVER |
Replace the door control receiver with a normal one.
Perform the registration procedure.
- OK:
- The system returns to normal operation.
|
|
||||
| OK | ||
| ||


