2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Power Source Circuit

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

The certification ECU provides power for the door control receiver operation.

WIRING DIAGRAM

B139463E01

INSPECTION PROCEDURE


1. INSPECT CERTIFICATION ECU (+B TERMINAL)

  1. B139430E02
    Measure the voltage according to value(s) in the table below.

    Standard voltage:
    Symbol
    (Tester Connection)
    Condition
    Specified Condition
    +B (E58-1) - E (E58-17)
    Always
    10 to 14 V



NG
REPLACE CERTIFICATION ECU
OK


2. INSPECT CERTIFICATION ECU (RC0 TERMINAL)

  1. B139430E03
    Measure the voltage according to value(s) in the table below.

    Standard voltage:
    Symbol
    (Tester Connection)
    Condition
    Specified Condition
    RC0 (E58-29) - E (E58-17)
    Engine switch off, all doors closed and transmitter switch not pressed
    Below 1 V
    Engine switch off, all doors closed and transmitter switch pressed
    4.6 to 5.4 V



NG
Go to step 5
OK


3. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - DOOR CONTROL RECEIVER)

  1. B139429E01
    Disconnect the E58 certification ECU connector.

  1. Disconnect the O18 door control receiver connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Symbol
    (Tester Connection)
    Condition
    Specified Condition
    RC0 (E58-29) - +5 (O18-2)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


4. CHECK HARNESS AND CONNECTOR (BODY GROUND)

  1. B139462E01
    Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Symbol
    (Tester Connection)
    Condition
    Specified Condition
    GND (O18-6) - Body ground
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE

5. CHECK HARNESS AND CONNECTOR (CERTIFICATION ECU - BATTERY - BODY GROUND)
  1. Disconnect the E58 certification ECU connector.

  1. E125974E10
    Measure the voltage and resistance according to value(s) in the table below.

    Standard:
    Symbol
    (Tester Connection)
    Condition
    Specified Condition
    RC0 (E58-29) - Body ground
    Always
    Below 1 V
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE CERTIFICATION ECU


← Wireless Door Lock Buzzer Circuit (from Oct 2006)PARTS LOCATION (Jun 2006 – Sep 2006) →