Check if any optional components, such as sunshade film or telephone antenna that may decrease reception capacity, are installed.
OK:
Optional components are installed.
NOTICE:
Do not remove any optional components installed by the customer without his or her consent.
OK
REMOVE AND RECHECK OPTIONAL COMPONENTS (SEE NOTICE ABOVE)
NG
4. CHECK NAVIGATION RECEIVER ASSEMBLY
Preparation for check
Remove the antenna plug from the navigation receiver assembly.
Check for noise
Turn the ignition switch to the ACC position with the navigation receiver assembly connector connected.
Turn the radio on and put into AM mode.
Place a screwdriver, thin wire, or other metal object on the navigation receiver assembly's antenna jack and check that noise can be heard from the speaker.
OK:
Noise occurs.
NG
REPLACE NAVIGATION RECEIVER ASSEMBLY
OK
5. CHECK GLASS ANTENNA
Check for continuity of the antenna.
HINT:
Check for continuity at the center of each antenna wire as shown in the illustration.
NOTICE:
When cleaning the glass, wipe it in the direction of the wire with a soft dry cloth. Take care not to damage the wire. Do not use detergents or glass cleaners with abrasive ingredients. When measuring resistance, wrap a piece of tin foil around the tip of the negative probe and press the foil against the wire with your finger, as shown in the illustration.
OK:
There is continuity in the antenna.
NG
REPAIR GLASS ANTENNA
OK
6. REPLACE ANTENNA AMPLIFIER
Replace the antenna amplifier and check that it operates normally.