FAIL-SAFE CHART
System information · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
If any of the following DTCs are set, the ECM enters fail-safe mode to allow the vehicle to be driven temporarily.
NOTE:
*: The vehicle can be driven slowly when the accelerator pedal is depressed slowly. If the accelerator pedal is depressed quickly, the vehicle may speed up and slow down erratically.
| DTCs |
Components |
Fail-Safe Operations |
Fail-Safe Deactivation Conditions |
| P0031, P0032, P0051 and P0052 |
Air-Fuel Ratio (A/F) Sensor Heater |
ECM turns off A/F sensor heater |
Ignition switch off |
| P0037, P0038, P0057 and P0058 |
Heated Oxygen (HO2) Sensor Heater |
ECM turns off HO2 sensor heater |
Ignition switch off |
| P0100, P0102 and P0103 |
Mass Air Flow (MAF) Meter |
ECM calculates ignition timing according to engine speed and throttle valve position |
Pass condition detected |
| P0110, P0112 and P0113 |
Intake Air Temperature (IAT) Sensor |
ECM estimates IAT to be 20°C (68°F) |
Pass condition detected |
| P0115, P0117 and P0118 |
Engine Coolant Temperature (ECT) Sensor |
ECM estimates ECT to be 80°C (176°F) |
Pass condition detected |
| P0120, P0121, P0122, P0123, P0220, P0222, P0223, P0604, P0606, P0607, P0657, P2102, P2103, P2111, P2112, P2118, P2119 and P2135 |
Electronic Throttle Control System (ETCS) |
ECM cuts off throttle actuator current and throttle valve returned to 6.5° throttle position by return spring ECM then adjusts engine output by controlling fuel injection (intermittent fuel-cut) and ignition timing in accordance with accelerator pedal opening angle, to allow vehicle to continue at minimal speed* |
Pass condition detected and then ignition switch turned off |
| P0327, P0328, P0332 and P0333 |
Knock Sensor |
ECM sets ignition timing to maximum retard |
Ignition switch off |
| P0351 to P0356 |
Igniter |
ECM cuts fuel |
Pass condition detected |
| P2120, P2121, P2122, P2123, P2125, P2127, P2128 and P2138 |
Accelerator Pedal Position (APP) Sensor |
APP sensor has 2 sensor circuits: Main and Sub If either of circuit malfunctions, ECM controls engine using the other circuit If both of circuits malfunction, ECM regards accelerator pedal as being released. As a result, throttle valve is closed and engine idles |
Pass condition detected and then ignition switch turned off |
*: The vehicle can be driven slowly when the accelerator pedal is depressed slowly. If the accelerator pedal is depressed quickly, the vehicle may speed up and slow down erratically.