REMOVAL
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| 1.
REMOVE FRONT BUMPER ASSEMBLY (w/o Fog Light)
|
 |
- Put protective tape around the front bumper assembly.
- Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
- HINT:
- Use the same procedure for the RH side and LH side.
- Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.
- Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.
- HINT:
- Use the same procedure for the RH side and LH side.
Remove the front bumper assembly.
| 2.
REMOVE FRONT BUMPER ASSEMBLY (w/ Fog Light)
|
 |
- Put protective tape around the front bumper assembly.
- Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
- HINT:
- Use the same procedure for the RH side and LH side.
- Remove the 8 screws, 2 clips, 2 radiator grille protectors and bolt.
- Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.
- HINT:
- Use the same procedure for the RH side and LH side.
Disconnect each connector, and then remove the front bumper assembly.
| 3.
REMOVE HIGH PITCHED HORN ASSEMBLY |
 |
- Disconnect the connector.
Remove the bolt and the high pitched horn assembly.