INSTALLATION
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009
| 1.
INSTALL POWER SEAT SWITCH |
 |
- Connect the connector.
Install the power seat switch with the 3 screws.
| 2.
INSTALL FRONT SEAT CUSHION SHIELD ASSEMBLY
|
 |
- Connect the connector.
Engage the 2 claws.
Install the front seat cushion shield assembly with the 5 screws.
- Install the 2 rubber bands on the backside of the front seatback board sub-assembly.
| 3.
INSTALL SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
|
 |
- Install the slide and vertical power seat switch knob.
| 4.
INSTALL RECLINING POWER SEAT SWITCH KNOB
|
 |
- Install the reclining power seat switch knob.
| 5.
INSTALL FRONT SEAT ASSEMBLY
|
 |
Place the seat in the cabin.
Connect the connectors under the seat.
Connect the cable to the negative (-) battery terminal.
Move the front seat assembly to the rearmost position by operating the slide and vertical power seat switch knob.
- Temporarily install the front side of the front seat assembly with the 2 bolts.
Move the front seat assembly fully forward by operating the slide and vertical power seat switch knob.
- Temporarily install the rear side of the front seat assembly with the 2 bolts.
Move the front seat assembly to the rearmost position by operating the slide and vertical power seat switch knob.
Fully tighten the 2 bolts on the front side of the front seat assembly in the order of the inner side bolt and then the outer side bolt.
-
Torque:
- 37 N*m{
377 kgf*cm
, 27 ft.*lbf
}
Move the front seat assembly fully forward by operating the slide and vertical power seat switch knob.
Fully tighten the 2 bolts on the rear side of the front seat assembly in the order of the inner side bolt and then the outer side bolt.
-
Torque:
- 37 N*m{
377 kgf*cm
, 27 ft.*lbf
}
| 6.
INSTALL INNER SEAT TRACK BRACKET COVER
|
 |
- Slide the inner seat track bracket cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.
Push the inner seat track bracket cover to engage claw B.
| 7.
INSTALL OUTER SEAT TRACK BRACKET COVER
|
 |
- Slide the outer seat track bracket cover along the seat rail toward the front of the vehicle. Engage claw A to the seat rail.
Push the seat track cover to engage claw B.
| 8.
INSPECT SRS WARNING LIGHT (w/ Airbag System) |
 |
Inspect the SRS warning light. (Click here)
| 9.
INSPECT FRONT SEAT ASSEMBLY
|
 |
Inspect the power seat operation.