Using a screwdriver, disengage the 4 claws and remove the front seat rear inner track bracket cover.
HINT:
Tape the screwdriver tip before use.
7.
REMOVE FRONT SEAT ASSEMBLY (for LHD)
Operate the power seat switch knob and move the seat to the rearmost position.
Remove the 2 bolts on the front seat track bracket.
Operate the power seat switch knob and move the seat to the position farthest forward.
Remove the 2 bolts on the rear seat track bracket.
Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent the airbag and seat belt pretensioner from deploying (Click here).
Disconnect the connectors under the seat. Then remove the front seat assembly.
8.
REMOVE FRONT SEAT ASSEMBLY (for RHD)
Operate the power seat switch knob and move the seat to the rearmost position.
Remove the 2 bolts on the front seat track bracket.
Operate the power seat switch knob and move the seat to the position farthest forward.
Remove the 2 bolts on the rear seat track bracket.
Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent the airbag and seat belt pretensioner from deploying (Click here).
Disconnect the connectors under the seat. Then remove the front seat assembly.
9.
REMOVE RECLINING POWER SEAT SWITCH KNOB (for LHD)
Using a screwdriver, detach the reclining power seat switch knob.
HINT:
Tape the screwdriver tip before use.
10.
REMOVE RECLINING POWER SEAT SWITCH KNOB (for RHD)
Using a screwdriver, detach the reclining power seat switch knob.
HINT:
Tape the screwdriver tip before use.
11.
REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB (for LHD)
Using a screwdriver, detach the slide and vertical power seat switch knob.
HINT:
Tape the screwdriver tip before use.
12.
REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB (for RHD)
Using a screwdriver, detach the slide and vertical power seat switch knob.
HINT:
Tape the screwdriver tip before use.
13.
REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY (for LHD)
Disconnect the 2 hooks.
Remove the 5 screws.
Disengage the 2 claws and separate the front seat cushion assembly.
Disconnect the connector from the front power seat lumbar switch.
14.
REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY (for RHD)
Disengage the 2 hooks.
Remove the 5 screws.
Disengage the 2 claws and separate the front seat cushion shield assembly.
Disconnect the connector from the front power seat lumbar switch.
15.
REMOVE POWER SEAT SWITCH (for LHD)
Remove the 3 screws.
Disconnect the connector and remove the power seat switch.
16.
REMOVE POWER SEAT SWITCH (for RHD)
Remove the 3 screws.
Disconnect the connector and remove the power seat switch.