Using a screwdriver, disengage the 4 claws and remove the inner seat track bracket cover.
HINT:
Tape the screwdriver tip before use.
6.
REMOVE INNER SEAT TRACK BRACKET COVER (for Power Seat)
Using a screwdriver, detach the 4 claws and remove the inner seat track bracket cover.
7.
REMOVE FRONT SEAT ASSEMBLY (for Manual Seat)
Move the front seat assembly to the rearmost position by operating the slide handle.
Remove the 2 bolts on the front seat track bracket.
Move the front seat assembly fully forward by operating the slide handle.
Remove the 2 bolts on the rear seat track bracket.
Move the front seat assembly to the center position and adjust the seatback to the vertical position by operating the slide and reclining adjuster release handle.
Disconnect the connectors and clamp.
Remove the front seat assembly.
8.
REMOVE FRONT SEAT ASSEMBLY (for Power Seat)
Operate the power seat switch knob and move the seat to the rearmost position.
Remove the 2 bolts on the front seat track bracket.
Operate the power seat switch knob and move the seat to the position farthest forward.
Remove the 2 bolts on the rear seat track bracket.
Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent the airbag and seat belt pretensioner from deploying (Click here).
Disconnect the connectors under the seat. Then remove the front seat assembly.