B1422/22 Compressor Lock Sensor Circuit
Diagnostic trouble codes · Vehicles built from Oct 2006
SYSTEM DESCRIPTION
The ECM sends a signal to the A/C amplifier via CAN communication.The A/C amplifier reads the difference between compressor speed and engine speed. When the difference becomes too large, the A/C amplifier determines that the compressor locks, and turns the magnetic clutch off.
| DTC No. |
DTC Detection Condition |
Trouble Area |
| B1422/22 |
Open or short in compressor lock sensor circuit |
|
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK CAN COMMUNICATION SYSTEM |
Use the intelligent tester to check if the CAN communication system is functioning normally.
- Result:
Result
Proceed to
CAN DTC is not output
A
CAN DTC is output
B
|
|
||||
| A | |
| 2. INSPECT AIR CONDITIONING AMPLIFIER |
Remove the A/C amplifier with the connectors still connected.

Measure the waveform of the connector.

Item
Contents
Tool setting
200 mV/DIV., 10 ms./DIV.
Vehicle condition
Engine is running
A/C switch: ON
Blower switch: LO
- Standard:
Tester Connection (Symbols)
Condition
Specified Condition
E38-8 (LOCK) - E38-13 (SG-2)
Engine is running
A/C switch: ON
Blower switch: LO
Pulse generation
- Result:
Result
Proceed to
NG
A
OK (When troubleshooting according to the PROBLEM SYMPTOMS TABLE)
B
OK (When troubleshooting according to the DTC)
C
|
|
||||
|
|
||||
| A | |
| 3. INSPECT COMPRESSOR AND MAGNETIC CLUTCH (A/C LOCK SENSOR) |
Disconnect the connector from the A/C compressor.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
C53-1 (SSR+) - C53-2 (SSR-)
20°C (68°F)
160 to 320 Ω
|
|
||||
| OK | |
| 4. CHECK HARNESS AND CONNECTOR (A/C AMPLIFIER - A/C LOCK SENSOR) |
Disconnect the connector from the A/C amplifier.

Measure the resistance according to the value(s) in the table below.

- Standard resistance:
Tester Connection (Symbols)
Condition
Specified Condition
E38-8 (LOCK) - C53-1 (SSR+)
Always
Below 1 Ω
E38-13 (SG-2) - C53-2 (SSR-)
Always
Below 1 Ω
E38-8 (LOCK) - Body ground
Always
10 kΩ or higher
E38-13 (SG-2) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
