REMOVAL
Removal / installation · Vehicles built Jun 2006 – Sep 2006
| 1. EJECT MAP DISC |
Turn the ignition switch to the ACC position.
Push the "CLOSE" button.
Touch "MAP EJECT" on the navigation screen to eject the map disc.
| 2. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY |
Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly.

| 3. REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
Disengage the 2 clips and remove the No. 1 instrument cluster finish panel garnish.

| 4. REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH |
Disengage the 2 clips and remove the No. 2 instrument cluster finish panel garnish.

| 5. REMOVE POSITION INDICATOR HOUSING ASSEMBLY |
Open the lid of the upper console panel.

Apply protective tape to the area shown in the illustration.
Using a moulding remover, disengage the 2 claws and the 5 clips, and then remove the position indicator housing assembly as shown in the illustration.

| 6. REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY |
Disengage the 3 claws and the 5 clips, and remove the upper console rear panel sub-assembly.

| 7. REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL CENTER SUB-ASSEMBLY |
Remove the 2 screws <F>.

Disengage the 4 claws.
Disconnect each connector and remove the instrument cluster finish panel center sub-assembly.
- HINT:
- Set the shift lever in the D position.
| 8. REMOVE INSTRUMENT PANEL NO. 2 REGISTER ASSEMBLY |
Apply protective tape to the areas shown in the illustration.

Using a moulding remover, disengage the 3 clips.

Using a moulding remover, disengage the 4 clips.

Disconnect the connector and remove the instrument panel No. 2 register assembly.
| 9. REMOVE NAVIGATION RECEIVER WITH HEATER CONTROL PANEL ASSEMBLY |
Remove the 4 bolts.

Pull the navigation receiver with heater control panel assembly toward the rear of the vehicle and disengage the 4 clips.
Disconnect each connector and remove the navigation receiver with heater control panel assembly.
| 10. REMOVE RADIO NO. 1 BRACKET |
Remove the 3 bolts and 2 screws and radio No. 1 bracket.

| 11. REMOVE RADIO NO. 2 BRACKET |
Remove the 3 bolts and 2 screws and radio No. 2 bracket.

| 12. REMOVE NAVIGATION RECEIVER ASSEMBLY |
Remove the navigation receiver assembly as shown in the illustration.

