REMOVAL
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| 1.
EJECT MAP DISC |
 |
Turn the ignition switch to the ACC position.
Push the "CLOSE" button.
Touch "MAP EJECT" on the navigation screen to eject the map disc.
| 2.
REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY
|
 |
- Turn the shift lever knob counterclockwise and remove the shift lever knob sub-assembly.
| 3.
REMOVE NO. 2 INSTRUMENT CLUSTER FINISH PANEL GARNISH
|
 |
- Disengage the 2 clips and remove the No. 2 instrument cluster finish panel garnish.
| 4.
REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL GARNISH
|
 |
- Disengage the 2 clips and remove the No. 1 instrument cluster finish panel garnish.
| 5.
REMOVE POSITION INDICATOR HOUSING ASSEMBLY
|
 |
- Open the lid of the upper console panel.
Apply protective tape to the area shown in the illustration.
- Using a moulding remover, disengage the 2 claws and the 5 clips, and then remove the position indicator housing assembly as shown in the illustration.
| 6.
REMOVE UPPER CONSOLE REAR PANEL SUB-ASSEMBLY
|
 |
- Disengage the 3 claws and the 5 clips, and remove the upper console rear panel sub-assembly.
| 7.
REMOVE LOWER INSTRUMENT CLUSTER FINISH PANEL CENTER SUB-ASSEMBLY
|
 |
- Remove the 2 screws <F>.
Disengage the 4 claws.
Disconnect each connector and remove the instrument cluster finish panel center sub-assembly.
- HINT:
- Set the shift lever in the D position.
| 8.
REMOVE INSTRUMENT PANEL NO. 2 REGISTER ASSEMBLY
|
 |
- Apply protective tape to the areas shown in the illustration.
- Using a moulding remover, disengage the 3 clips.
- Using a moulding remover, disengage the 4 clips.
Disconnect the connector and remove the instrument panel No. 2 register assembly.
| 9.
REMOVE NAVIGATION RECEIVER WITH HEATER CONTROL PANEL ASSEMBLY |
 |
- Remove the 4 bolts.
Pull the navigation receiver with heater control panel assembly toward the rear of the vehicle and disengage the 4 clips.
Disconnect each connector and remove the navigation receiver with heater control panel assembly.
| 10.
REMOVE RADIO NO. 1 BRACKET |
 |
- Remove the 3 bolts and 2 screws and radio No. 1 bracket.
| 11.
REMOVE RADIO NO. 2 BRACKET |
 |
- Remove the 3 bolts and 2 screws and radio No. 2 bracket.
| 12.
REMOVE NAVIGATION RECEIVER ASSEMBLY |
 |
- Remove the navigation receiver assembly as shown in the illustration.