2006-2011 Camry Aurion · Service Manual BODY

REASSEMBLY

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


1. INSTALL REAR BUMPER REINFORCEMENT SUB-ASSEMBLY

  1. B149452
    Install the rear bumper reinforcement sub-assembly with the 6 nuts.

    Torque:
    68 N*m{ 693 kgf*cm , 50 ft.*lbf }


2. INSTALL WHEEL HOUSE REINFORCEMENT LH

  1. B137221
    Install the wheel house reinforcement LH with the nut.


3. INSTALL WHEEL HOUSE REINFORCEMENT RH

HINT:
Use the same procedure for the RH side and LH side.


4. INSTALL REAR BUMPER SIDE RETAINER LH

  1. B137220
    Engage the 3 claws and install the rear bumper side retainer LH.

  1. Install the 2 screws.


5. INSTALL REAR BUMPER SIDE RETAINER RH

HINT:
Use the same procedure for the RH side and LH side.


6. INSTALL REAR BUMPER SIDE SUPPORT LH

  1. B137219
    Engage the 3 claws and install the rear bumper side support LH.

  1. Install the 2 screws.


7. INSTALL REAR BUMPER SIDE SUPPORT RH

HINT:
Use the same procedure for the RH side and LH side.


8. INSTALL REAR BUMPER PAD

  1. B146333
    Apply new double-sided tape to the rear bumper pad.

  1. Remove the release paper from the rear bumper pad.

  1. Install the rear bumper pad.

    HINT:
    Use the same procedures for the RH side and LH side.


9. INSTALL REAR BUMPER PLATE LH

10. INSTALL REAR BUMPER PLATE RH

11. INSTALL REAR BUMPER EXTENSION LH (w/ Rear Lower Spoiler)

  1. B137222
    Install the rear bumper extension LH with the 2 nuts.


12. INSTALL REAR BUMPER EXTENSION RH (w/ Rear Lower Spoiler)

HINT:
Use the same procedure for the RH side and LH side.


13. INSTALL REAR LOWER SPOILER (w/ Rear Lower Spoiler)

  1. Engage the 16 claws and install the rear lower spoiler.

    B137223

  1. Install the 16 clips, 4 nuts and 2 screws.


14. INSTALL NO. 2 LUGGAGE ROOM WIRE (w/ Clearance Sonar System)

  1. E134863E03
    Install the No. 2 ultrasonic sensor retainer to the rear bumper.
    Text in Illustration 
    *1
    Snap
    *2
    Keyhole

    NOTICE:
    Do not damage the bumper with the snap when installing the retainer.

    HINT:
    When installing the retainer, align the keyhole and snap as shown in the illustration.


15. INSTALL NO. 2 ULTRASONIC SENSOR RETAINER (w/ Clearance Sonar System)

  1. E205958
    Engage the 2 claws and install the No. 2 ultrasonic sensor.

  1. Connect each sensor connector.

  1. E205959
    Install the sensor retainer as shown in the illustration.


16. INSTALL NO. 2 ULTRASONIC SENSOR (w/ Clearance Sonar System)
← REASSEMBLY (Jun 2006 – May 2009)INSTALLATION (Jun 2006 – May 2009) →