2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment (Click here).


2. REMOVE LOWER NO. 3 STEERING WHEEL COVER

  1. Using a screwdriver, disengage the claw and remove the No. 3 lower steering wheel cover.

    C146012E01

    HINT:
    Tape up the screwdriver tip before use.


3. REMOVE LOWER NO. 2 STEERING WHEEL COVER

  1. Using a screwdriver, disengage the claw and remove the No. 2 lower steering wheel cover.

    C146013E01

    HINT:
    Tape up the screwdriver tip before use.


4. REMOVE STEERING PAD

  1. Using a "TORX" socket (T30), loosen the 2 "TORX" screws until the groove along the screw circumference catches on the screw case.

    C146014E01

  1. C133859E01
    Pull out the steering pad from the steering wheel assembly and support the steering pad with one hand.

    NOTICE:
    When removing the steering pad, do not pull the airbag wire harness.

  1. Disconnect the horn connector from the steering pad.

  1. Disconnect the 2 airbag connectors and remove the steering pad.

    NOTICE:
    When handling the airbag connector, take care not to damage the airbag wire harness.


5. REMOVE STEERING PAD SWITCH LH (for 4 Spoke)

  1. E136757E01
    Disconnect the pad switch connector from the spiral cable and disengage the clamp.

  1. Remove the screw.

  1. Disengage the 2 pins and remove the steering pad switch LH.


6. REMOVE STEERING PAD SWITCH ASSEMBLY (for 4 Spoke)

  1. E136757E01
    Disconnect the pad switch connector from the spiral cable and disengage the clamp.

  1. Remove the screw.

  1. Disengage the 2 pins and remove the steering pad switch.

  1. E136758E01
    Disengage the clamp and remove the screw.

  1. Disengage the 2 pins and remove the steering pad switch assembly.


7. REMOVE STEERING PAD SWITCH LH (for 3 Spoke)

  1. E136759E01
    Disconnect the pad switch connector from the spiral cable and disengage the clamp.

  1. Remove the screw.

  1. Disengage the 2 pins and remove the steering pad switch LH.


8. REMOVE STEERING PAD SWITCH ASSEMBLY (for 3 Spoke)

  1. E136760E01
    Disconnect the pad switch connector from the spiral cable.

  1. Disengage the clamp and remove the screw.

  1. Disengage the 2 pins and remove the steering pad switch.

  1. E136761E01
    Disengage the clamp and remove the screw.

  1. Disengage the 2 pins and remove the steering pad switch assembly.

← REMOVAL (Oct 2006 – May 2009)INSPECTION (from Jun 2006) →