2006-2011 Camry Aurion · Service Manual ENGINE

INSPECTION

Inspection · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009


INSPECT CHAIN SUB-ASSEMBLY

  1. A135727E01
    Pull the chain with a force of 140 N (14.3 kgf, 31.5 lbf) as shown in the illustration.

  1. Using vernier calipers, measure the length of 15 links.

    Maximum chain elongation:
    114.5 mm (4.508 in.)

    NOTICE:
    Perform the measurement at 3 random places. Use the average of the measurements.

    If the average elongation is greater than the maximum, replace the chain.


INSPECT NO. 2 CHAIN SUB-ASSEMBLY

  1. A135727E01
    Pull the chain with a force of 140 N (14.3 kgf, 31.5 lbf) as shown in the illustration.

  1. Using vernier calipers, measure the length of 15 links.

    Maximum chain elongation:
    102.2 mm (4.024 in.)

    NOTICE:
    Perform the measurement at 3 random places. Use the average of the measurements.

    If the average elongation is greater than the maximum, replace the No. 2 chain.


INSPECT OIL PUMP DRIVE GEAR

  1. A053035E01
    Place the chain around the gear.

  1. Using vernier calipers, measure the diameter of the gear and chain.

    Minimum gear diameter (with chain):
    48.2 mm (1.898 in.)

    NOTICE:
    The vernier calipers must be in contact with the chain rollers when measuring.

    If the diameter is less than the minimum, replace the chain and gear.


INSPECT OIL PUMP DRIVE SHAFT GEAR

  1. A053036E01
    Place the chain around the gear.

  1. Using vernier calipers, measure the diameter of the gear and chain.

    Minimum gear diameter (with chain):
    48.2 mm (1.898 in.)

    NOTICE:
    The vernier calipers must be in contact with the chain rollers when measuring.

    If the diameter is less than the minimum, replace the chain and gear.


INSPECT CHAIN TENSIONER SLIPPER

  1. A033838E01
    Using vernier calipers, measure the tensioner slipper wear.

    Maximum wear:
    1.0 mm (0.039 in.)

    If the wear is greater than the maximum, replace the chain tensioner slipper.


INSPECT NO. 1 CHAIN VIBRATION DAMPER

  1. A036686E01
    Using vernier calipers, measure the vibration damper wear.

    Maximum wear:
    1.0 mm (0.039 in.)

    If the wear is greater than the maximum, replace the No. 1 chain vibration damper.


INSPECT CHAIN TENSIONER PLATE

  1. A126893
    Using vernier calipers, measure the chain tensioner plate wear.

    Maximum wear:
    0.5 mm (0.020 in.)

    If the wear is greater than the maximum, replace the chain tensioner plate.


INSPECT NO. 1 CHAIN TENSIONER

  1. A098357E01
    Check that the plunger moves smoothly when the ratchet pawl is raised with your finger.

  1. Release the ratchet pawl, then check that the plunger is locked in place by the ratchet pawl and does not move when pushed with your finger.

← REMOVAL (from Jun 2009)INSPECTION (Oct 2006 – May 2009) →