2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

U0100 Lost Communication with ECM / PCM "A"

Diagnostic trouble codes · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The combination meter assembly communicates with the ECM via the CAN communication lines (CAN No. 1 Bus).
DTC No.
DTC Detection Conditions
Trouble Areas
U0100
When IG voltage is 9.5 V or more and the following condition is detected:
  1. No communication with ECM continues for 3 seconds or more
  1. CAN communication system
  2. ECM

WIRING DIAGRAM

E124226E06

INSPECTION PROCEDURE


1. CONFIRM DTC OUTPUT
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch to the ON position.

  1. Turn the tester on.

  1. Clear the stored DTCs by selecting the following menu items on the tester: Body / Combination Meter / DTC Info / Clear Codes.

  1. Drive the vehicle at more than 5 km/h (3.1 mph) for at least 60 seconds.

  1. Stop the vehicle.

  1. Check for DTCs (Click here for LHD, Click here for RHD).

    Result:
    Result
    Proceed to
    DTC is output.
    A (Click here for LHD, Click here for RHD)
    DTC is not output.
    B



B
USE SIMULATION METHOD TO CHECK
A

GO TO CAN COMMUNICATION SYSTEM


← ON-VEHICLE INSPECTION (from Jun 2009)U0100 Lost Communication with ECM / PCM "A" (Oct 2006 – May 2009) →