2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

REMOVAL

Removal / installation · Vehicles built Jun 2006 – May 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


1. DISCHARGE FUEL SYSTEM PRESSURE

HINT:
(Click here)


2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.


3. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fold Down Seat Type)

  1. B134699E01
    Detach the 2 front hooks of the seat cushion from the vehicle body.

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat the step above for the other hook.

  1. Remove the seat cushion.


4. REMOVE REAR SEAT CUSHION ASSEMBLY (for Fixed Seat Type)

  1. B136575E01
    Detach the 2 front hooks of the seat cushion from the vehicle body.

    NOTICE:
    Follow the instructions below carefully as the cushion frame can be deformed easily.


    1. Choose a hook to detach first. Place your hands near the hook as shown in the illustration. Then lift the seat cushion to detach the hook.

    2. Repeat the step above for the other hook.

  1. Remove the rear seat cushion assembly.


5. REMOVE REAR FLOOR SERVICE HOLE COVER

  1. A129478
    Remove the rear floor service hole cover.

  1. Disconnect the fuel pump connector.


6. SEPARATE FUEL PUMP TUBE SUB-ASSEMBLY

  1. A129479E02
    Remove the tube joint clip, and pull out the fuel pump tube.

    NOTICE:
    1. Check that there is no dirt around the fuel tube joint before this work and clean the dirt away.
    2. Be careful of dirt and mud because the fuel tube joint has O-rings to seal the fuel tube connector and fuel suction plate.
    3. Do not use any tools in this work.
    4. Do not bend or twist the nylon tube by force.
    5. After disconnecting, cover the fuel tube joint with a plastic bag.
    6. When the fuel tube joint and fuel suction plate are stuck, pinch the fuel tank tube between fingers, and turn it carefully to release. Disconnect the fuel tank tube.


7. REMOVE FUEL TANK VENT TUBE SET PLATE

  1. A129480
    Remove the 8 bolts and set plate.


8. REMOVE FUEL SUCTION TUBE ASSEMBLY WITH PUMP AND GAUGE

  1. A139190
    Pull out the fuel suction tube from the fuel tank.

    NOTICE:
    1. Do not damage the fuel pump filter.
    2. Be careful that the arm of the sender gauge does not bend.

  1. A136023E01
    Remove the gasket from the fuel suction tube.


9. REMOVE FUEL SENDER GAUGE ASSEMBLY

  1. A136021
    Disconnect the fuel sender gauge connector.

  1. A136022
    Unlock the fuel sender gauge, and slide it to remove.

← COMPONENTS (from Jun 2006)REMOVAL (from Jun 2009) →