2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TERMINALS OF ECU

System information · Vehicles built from Jun 2009

Versions by build date: Jun 2006 – May 2009 from Jun 2009


CHECK MAIN BODY ECU (INSTRUMENT PANEL J/B)
E111961E05
  1. Disconnect the IA, ID, IF and IM J/B connectors.

  2. Measure the voltage and resistance between the specified terminals of the wire harness side connectors and body ground.

    Standard voltage:
    Symbols
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    IA-1 - Body ground
    B - Body ground
    Battery power supply
    Always
    10 to 14 V
    ALTB (ID-16) - Body ground
    W - Body ground
    Generator power supply
    Always
    10 to 14 V


    Standard resistance:
    Symbols
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    GND1 (IF-10) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    GND2 (IM-9) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω

    If the result is not as specified, there may be a malfunction on the wire harness side.

  3. Reconnect the IA, ID, IF, and IM J/B connectors.

  4. Measure the resistance and voltage between the specified terminals of the J/B connectors and body ground.

    Standard resistance:
    Symbols
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    CLTE (E6-18)*1 - Body ground
    BR - Body ground
    Automatic light control sensor ground
    Always
    Below 1 Ω


    Standard voltage:
    Symbols
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    HRLY (ID-3) - Body ground
    P - Body ground
    Headlight relay drive output
    Light control switch in HEAD
    Below 1 V
    Light control switch not in HEAD
    10 to 14 V
    DIM (ID-9) - Body ground
    V - Body ground
    High beam headlight relays drive output
    Dimmer switch in HIGH or HIGH FLASH
    Below 1 V
    Dimmer switch in LOW
    10 to 14 V
    HU (IG-5) - Body ground
    LG - Body ground
    Dimmer switch HIGH input
    Dimmer switch in HIGH
    10 to 14 V
    Dimmer switch in LOW
    Below 1 V
    ILE (II-10)*4 - Body ground
    BR - Body ground
    Interior light and ignition key cylinder light drive output
    Interior light and ignition key cylinder light ON
    Below 1 V
    Interior light and ignition key cylinder light OFF
    10 to 14 V
    LCTY (IO-7) - Body ground
    LG - Body ground
    Rear left door courtesy switch input
    Rear left door open
    Below 1 V
    Rear left door closed
    10 to 14 V
    LSWL (IP-5)*1, *5 - Body ground
    GR- Body ground
    Rear left door lock position switch input
    Rear left door locked
    10 to 14 V
    Rear left door unlocked
    Below 1 V
    RCTY (E6-5)*4 - Body ground
    GR - Body ground
    Rear right door courtesy switch input
    Rear right door open
    Below 1 V
    Rear right door closed
    10 to 14 V
    LSWR (E6-5)*1, *5 - Body ground
    V - Body ground
    Rear right door lock position switch input
    Rear right door locked
    10 to 14 V
    Rear right door unlocked
    Below 1 V
    RCTY (E6-7)*5 - Body ground
    GR - Body ground
    Rear right door courtesy switch input
    Rear right door open
    Below 1 V
    Rear right door closed
    10 to 14 V
    HEAD (E6-17) - Body ground
    P- Body ground
    Light control switch HEAD input
    Light control switch in HEAD
    Below 1 V
    Light control switch not in HEAD
    10 to 14 V
    CLTS (E6-19)*1 - Body ground
    G- Body ground
    Automatic light control sensor signal input
    Ignition switch off
    Below 1 V
    Automatic light control system operates
    Pulse generation
    (See waveform 1)
    CLTB (E6-20)*1 - Body ground
    B - Body ground
    Automatic light control sensor power supply output
    Ignition switch off
    Below 1 V
    Ignition switch ON and light control switch in AUTO
    10 to 14 V
    PCTY (E6-21) - Body ground
    L*1 - Body ground
    Y*2 - Body ground
    Passenger side door courtesy switch input
    Passenger side door open
    Below 1 V
    Passenger side door closed
    10 to 14 V
    LGCY (E6-25) - Body ground
    W - Body ground
    Luggage courtesy switch input
    Luggage compartment door open
    Below 1 V
    Luggage compartment door closed
    10 to 14 V
    LSWP (E6-27) - Body ground
    L*1, *4 - Body ground
    Passenger side and rear RH and rear LH door lock position switches input
    Passenger side and rear LH and rear RH doors locked
    10 to 14 V
    Passenger side or rear LH or rear RH door unlocked
    Below 1 V
    LG*2 - Body ground
    Passenger side door lock position switch input
    Passenger side door locked
    10 to 14 V
    Passenger side door unlocked
    Below 1 V
    FFOG (E6-28) *3 - Body ground
    V - Body ground
    Fog light switch FRONT input
    Fog light switch in FRONT
    Below 1 V
    Fog light switch OFF
    10 to 14 V
    FFGO (E7-4)*3 - Body ground
    R - Body ground
    Front fog light relay drive output
    Light control switch in TAIL and front fog light switch ON
    Below 1 V
    Fog light switch OFF
    10 to 14 V
    LSWD (E7-9) - Body ground
    Y*1 - Body ground
    L*2 - Body ground
    Driver side door lock position switch input
    Driver side door locked
    10 to 14 V
    Driver side door unlocked
    Below 1 V
    HF (E7-13) - Body ground
    R - Body ground
    Dimmer switch HIGH FLASH signal input
    Dimmer switch in HIGH FLASH position
    Below 1 V
    Dimmer switch not in HIGH FLASH position
    10 to 14 V
    A (E7-21)*1 - Body ground
    G - Body ground
    Light control switch AUTO signal input
    Light control switch in AUTO
    Below 1 V
    Light control switch not in AUTO
    10 to 14 V
    TAIL (E7-23) - Body ground
    B - Body ground
    Light control switch TAIL signal input
    Light control switch in TAIL or HEAD
    Below 1 V
    Light control switch in neither TAIL nor HEAD
    10 to 14 V
    DCTY (E7-24) - Body ground
    Y*1 - Body ground
    L*2 - Body ground
    Driver side door courtesy switch input
    Driver side door open
    Below 1 V
    Driver side door closed
    10 to 14 V
    CANH (E8-5) - Body ground
    B - Body ground
    CAN communication line H
    Ignition switch ON
    Pulse generation
    Ignition switch off
    Below 1 V
    CANL (E8-6) - Body ground
    W - Body ground
    CAN communication line L
    Ignition switch ON
    Pulse generation
    Ignition switch off
    Below 1 V

    If the result is not as specified, the main body ECU (Instrument panel J/B) may have a malfunction.

    HINT:
    *1: RHD
    *2: LHD
    *3: with Front Fog Light
    *4: without Smart Entry and Start System
    *5: with Smart Entry and Start System


    1. B113714E01
      Waveform 1
      Item
      Contents
      Tool setting
      5 V/DIV., 5 ms./DIV.

      HINT:
      If the ambient light becomes brighter, width A becomes narrower.

← TERMINALS OF ECU (Jun 2006 – May 2009)DIAGNOSIS SYSTEM (Jun 2006 – May 2009) →