2006-2011 Camry Aurion · Service Manual ENGINE

ON-VEHICLE INSPECTION

Inspection · Vehicles built from Oct 2006


CHECK ACCELERATOR PEDAL ASSEMBLY
  1. Measure the voltage.

    1. Connect the intelligent tester to the DLC3.

    2. Turn the ignition switch on (IG).

    3. Turn the intelligent tester on.

    4. Select the menu items: Powertrain / Engine / Data List / Accelerator Position No. 1 and Accelerator Position No. 2.

    5. Operate the accelerator pedal, and then check that the Accelerator Position No. 1 and Accelerator Position No. 2 values are within the specifications.

      Standard voltage (Accelerator Position No. 1):
      Accelerator Pedal Condition
      Specified Condition
      Released
      0.5 to 1.1 V
      Depressed
      2.5 to 4.5 V

      Standard voltage (Accelerator Position No. 2):
      Accelerator Pedal Condition
      Specified Condition
      Released
      1.2 to 2.0 V
      Depressed
      3.4 to 5.0 V

      If the result is not as specified, check the accelerator pedal assembly, wire harness or ECM.

← COMPONENTS (from Oct 2006)REMOVAL (from Oct 2006) →