Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009from Jun 2009
1.
REMOVE COOL AIR INTAKE DUCT SEAL
Remove the 7 clips and cool air intake duct seal.
2.
REMOVE FRONT BUMPER ASSEMBLY
Put protective tape around the front bumper assembly.
Using a screwdriver, turn the pin 90 degrees and remove the pin hold clip.
HINT:
Use the same procedure for the RH side and LH side.
Remove the 8 screws, 3 clips and 2 radiator grille protectors.
Disengage the 2 claws and disconnect the front bumper assembly as shown in the illustration.
HINT:
Use the same procedure for the RH side and LH side.
Disconnect each connector.
Disconnect the headlight cleaner washer hose, and then remove the front bumper assembly.
3.
REMOVE HEADLIGHT CLEANER CONTROL RELAY
Disconnect the connector.
Using a screwdriver wrapped with protective tape, disengage the claw while pushing down on the headlight cleaner control relay in the direction indicated by the arrow in the illustration to remove the relay.