2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Engine Switch Illumination Circuit

Circuit diagnosis · Vehicles built from Oct 2006

DESCRIPTION

The engine switch illumination is controlled by the main body ECU. The operation and condition of this control are described below.
Operation
Condition
Fade in
When any of the following conditions is met, the engine switch illumination fades in.
  1. Any door is opened.
  2. Any door is unlocked when the engine switch is off and all doors are closed.
  3. Engine switch is turned from on (ACC) to off when all doors are closed.
Fade out immediately
When either of the following conditions is met, the engine switch illumination fade out.
  1. Engine switch is turned from off to on (ACC or IG) when all doors are closed.
  2. All doors are locked when the engine switch is off.
Illuminate for approximately 15 seconds, and then fade out
All doors are closed when the engine switch is off.

WIRING DIAGRAM

E133241E02

INSPECTION PROCEDURE


1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER
  1. Connect the intelligent tester to the DLC3.

  1. Turn the ignition switch on (IG).

  1. Turn the intelligent tester main switch on.

  1. Select the item(s) below in the ACTIVE TEST, and check the operation.

    Main Body (Main Body ECU): 
    Tester Display
    Test Part
    Control Range
    Diagnostic Note
    Lighting Ind
    Engine switch illumination
    ON/OFF
    -

    OK:
    Engine switch illumination comes on.



OK
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE
NG


2. INSPECT ENGINE SWITCH

  1. Remove the engine switch.A109252E15

  1. Apply the battery voltage to the engine switch.

  1. Check that the illumination comes on.

OK:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 11 (SWIL)
Battery negative (-) → Terminal 5 (GND) or 4 (COM)
Engine switch illumination comes on



NG
REPLACE ENGINE SWITCH
OK


3. CHECK HARNESS OR CONNECTOR (ENGINE SWITCH - MAIN BODY ECU AND BODY GROUND)

  1. E121502E03
    Disconnect the E7 main body ECU connector.

  1. Disconnect the E52 engine switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    E52-11 (SWIL) - E7-25 (SWIL)
    Always
    Below 1 Ω
    E52-4 (COM) or E52-5 (GND) - Body ground
    Always
    Below 1 Ω
    E7-25 (SWIL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

REPLACE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY


← Interior Light Circuit (from Oct 2006)Taillight Relay Circuit (Oct 2006 – May 2009) →