Engine Switch Illumination Circuit
Circuit diagnosis · Vehicles built from Jun 2009
DESCRIPTION
The engine switch illumination is controlled by the main body ECU. The operation and condition of this control are described below.| Operation |
Condition |
| Fade in |
When any of the following conditions is met, the engine switch illumination fades in.
|
| Fade out immediately |
When either of the following conditions is met, the engine switch illumination fade out.
|
| Illuminate for approximately 15 seconds, and then fade out |
All doors are closed when the engine switch is off. |
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. PERFORM ACTIVE TEST USING INTELLIGENT TESTER |
Connect the intelligent tester to the DLC3.
Turn the engine switch on (IG).
Turn the intelligent tester main switch on.
Select the item(s) below in the ACTIVE TEST, and check the operation.
Main Body (Main Body ECU): Tester Display
Test Part
Control Range
Diagnostic Note
Lighting Ind
Engine switch illumination
ON/OFF
-
- OK:
- Engine switch illumination comes on.
|
|
||||
| NG | |
| 2. INSPECT ENGINE SWITCH |
Remove the engine switch.


Apply the battery voltage to the engine switch.
Check that the illumination comes on.
- OK:
Measurement Condition
Specified Condition
Battery positive (+) → Terminal 11 (SWIL)
Battery negative (-) → Terminal 5 (GND) or 4 (COM)
Engine switch illumination comes on
|
|
||||
| OK | |
| 3. CHECK HARNESS OR CONNECTOR (ENGINE SWITCH - MAIN BODY ECU AND BODY GROUND) |
Disconnect the E7 main body ECU connector.

Disconnect the E52 engine switch connector.
Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E52-11 (SWIL) - E7-25 (SWIL)
Always
Below 1 Ω
E52-4 (COM) or E52-5 (GND) - Body ground
Always
Below 1 Ω
E7-25 (SWIL) - Body ground
Always
10 kΩ or higher
|
|
||||
| OK | ||
| ||
