2006-2011 Camry Aurion · Service Manual BODY

REMOVAL

Removal / installation · Vehicles built Oct 2006 – May 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009


1. REMOVE LUGGAGE COMPARTMENT DOOR COVER

  1. B135465
    Using a clip remover, remove the 13 clips and luggage compartment door cover.


2. REMOVE REAR LIGHT ASSEMBLY LH

  1. E133813E01
    Disconnect the connector and clamp.

  1. Remove the 4 nuts and the rear light assembly.


3. REMOVE REAR LIGHT ASSEMBLY RH

HINT:
Use the same procedure for the RH side and LH side.


4. REMOVE LUGGAGE COMPARTMENT DOOR LOCK CYLINDER ASSEMBLY

  1. B146109
    Disconnect the cable and connector.

  1. B146110
    Remove the 2 nuts and the luggage compartment door lock cylinder assembly.


5. REMOVE LUGGAGE DOOR OPENING SWITCH ASSEMBLY (w/ Smart Entry and Start System)
  1. Disconnect the connector.

  1. B142421
    Remove the 2 nuts and the luggage door opening switch assembly.


6. REMOVE BACK DOOR GARNISH RETAINER (w/ Smart Entry and Start System)

  1. without Parking Assist Monitor System:

    1. B151763
      Remove the 2 nuts.

    2. B151764
      Disengage the 2 claws and remove the back door garnish retainer.


7. REMOVE TELEVISION CAMERA ASSEMBLY (w/ Parking Assist Monitor System)

  1. E134847E01
    Disengage the camera connector clamp.

  1. Disconnect the television camera connector.

  1. Remove the 2 nuts.

  1. E134848E01
    Disengage the 2 claws to remove the television camera assembly as shown in the illustration.


8. REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY (w/o Smart Entry and Start System)

  1. B149481E01
    Put protective tape around the luggage compartment door outside garnish sub-assembly.

  1. B149482
    Remove the 6 nuts.

  1. B159302E01
    Using a moulding remover, disengage the 4 clips and remove the luggage compartment door outside garnish sub-assembly.

    HINT:
    Disengage either lock on the clip to prevent the clip from breaking.


9. REMOVE LUGGAGE COMPARTMENT DOOR OUTSIDE GARNISH SUB-ASSEMBLY (w/ Smart Entry and Start System)

  1. B149481E01
    Put protective tape around the luggage compartment door outside garnish sub-assembly.

  1. B149484
    Remove the 2 nuts.

  1. B159302E01
    Using a moulding remover, disengage the 4 clips and remove the luggage compartment door outside garnish sub-assembly.

    HINT:
    Disengage either lock on the clip to prevent the clip from breaking.

← COMPONENTS (from Jun 2009)REMOVAL (from Jun 2009) →