Move the front passenger's seat assembly fully forward by operating the slide and vertical power seat switch knob.
Using a screwdriver, disengage the 4 claws and remove the outer seat track bracket cover.
HINT:
Tape the screwdriver tip before use.
3.
REMOVE INNER SEAT TRACK BRACKET COVER
Using a screwdriver, disengage the 4 claws and remove the inner seat track bracket cover.
HINT:
Tape the screwdriver tip before use.
4.
REMOVE FRONT SEAT ASSEMBLY
Operate the power seat switch knob and move the seat to the rearmost position.
Remove the 2 bolts on the front seat track bracket.
Operate the power seat switch knob and move the seat fully forward.
Remove the 2 bolts on the rear seat track bracket.
Disconnect the cable from the negative (-) battery terminal.
CAUTION:
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent the airbag and seat belt pretensioner from deploying (Click here).
Disconnect the connectors under the seat. Then remove the front passenger's seat assembly.
5.
REMOVE RECLINING POWER SEAT SWITCH KNOB
Using a screwdriver, remove the reclining power seat switch knob.
HINT:
Tape the screwdriver tip before use.
6.
REMOVE SLIDE AND VERTICAL POWER SEAT SWITCH KNOB
Using a screwdriver, remove the slide and vertical power seat switch knob.
HINT:
Tape the screwdriver tip before use.
7.
REMOVE FRONT SEAT CUSHION SHIELD ASSEMBLY
Disengage the 2 hooks.
Remove the 5 screws.
Disengage the 2 claws and separate the front seat cushion shield assembly.
Disconnect the connector from the front power seat lumbar switch.
8.
REMOVE FRONT INNER SEAT CUSHION SHIELD
Remove the screw.
Disengage the 3 claws and remove the front inner seat cushion shield.
9.
REMOVE FRONT SEAT INNER BELT ASSEMBLY
Disconnect the connectors and disengage the 2 clamps.
Remove the nut and front seat inner belt assembly.
10.
REMOVE FRONT POWER SEAT SWITCH
Remove the 3 screws.
Disconnect the connector and remove the front power seat switch.
11.
REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD
Disconnect the connector.
Disengage the 4 hooks.
Using a screwdriver, disengage the hooks and remove the separate type front seat cushion cover with pad.
12.
REMOVE SEPARATE TYPE FRONT SEAT CUSHION PAD
Remove the 14 hog rings and separate type front seat cushion pad from the separate type front seat cushion cover.