REMOVAL
Removal / installation · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
| 1.
REMOVE FRONT DOOR SCUFF PLATE RH |
 |
- HINT:
- Use the same procedure for the RH side and the LH side (Click here).
| 2.
REMOVE COWL SIDE TRIM SUB-ASSEMBLY RH |
 |
- HINT:
- Use the same procedure for the RH side and the LH side (Click here).
| 3.
REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL
|
 |
- Remove the bolt <D> and the screw <F>.
Disengage the 2 claws and the DLC3.
Disconnect the hood lock control cable assembly.
Disengage the claw and the 4 clips.
Remove the air hose, disconnect each connector, and then remove the lower No. 1 instrument panel finish panel.
| 4.
REMOVE NETWORK GATEWAY ECU |
 |
- Remove the 2 nuts and the bolt and disengage the wire harness clamp bracket with ECU.
- Turn the wire harness clamp bracket with ECU in the direction indicated by the arrow.
- NOTICE:
- Do not apply excessive force.
- Disconnect the connector.
- Remove the nut and network gateway ECU.