Indicator Circuit
Circuit diagnosis · Vehicles built from Oct 2006
DESCRIPTION
When the clearance sonar main switch is turned on, an ON signal is sent to the clearance warning ECU and the indicator on the switch comes on.WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK HARNESS AND CONNECTOR (CLEARANCE SONAR MAIN SWITCH - BODY GROUND) |
Remove the clearance sonar main switch assembly.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E73-7 (E) - Body ground
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
