Check that the battery negative (-) cable is disconnected.
CAUTION:
Wait for 90 seconds after disconnecting the cable to prevent airbag deployment.
Install the side airbag sensor with the bolt.
Torque:
9.0 N*m{
92 kgf*cm
, 80 in.*lbf
}
NOTICE:
If the side airbag sensor has been dropped, or there are any cracks, dents or other defects in the case, bracket or connector, replace it with a new one.
When installing the side airbag sensor, be careful that the SRS wiring does not interfere with other parts and that it is not pinched between other parts.
Check that there is no looseness in the installation parts of the side airbag sensor.
Connect the connector.
NOTICE:
When handling the airbag connector, take care not to damage the airbag wire harness.
2.
INSTALL LOWER CENTER PILLAR GARNISH
Engage the 2 claws and 2 clips, then install the lower center pillar garnish LH.
3.
INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP
Install the front door opening trim weatherstrip LH as shown in the illustration.
NOTICE:
After installation, check that the corners fit correctly.
4.
INSTALL FRONT DOOR SCUFF PLATE
Engage the 7 claws and 3 clips, then install the front door scuff plate LH.
5.
INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP
Install the rear door opening trim weatherstrip LH as shown in the illustration.
NOTICE:
After installation, check that the corners fit correctly.
6.
INSTALL REAR DOOR SCUFF PLATE
Engage the 5 claws and 2 clips, then install the rear door scuff plate LH.