Speed Signal Circuit
Circuit diagnosis · Vehicles built Oct 2006 – May 2009
Versions by build date: Oct 2006 – May 2009 from Jun 2009
DESCRIPTION
The windshield wiper relay assembly (auto wiper relay) receives a vehicle speed signal from a combination meter to control an automatic windshield wiper system.A voltage of 12 V or 5 V is output from the combination meter assembly and then input to the skid control ECU.
A voltage of 12 V or 5 V is output from each ECU or relay and then input to the combination meter assembly.
The signal is changed to a pulse signal at the transistor in the combination meter assembly.
Each ECU controls the respective system based on the pulse signal.
If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.
WIRING DIAGRAM


INSPECTION PROCEDURE
| 1. CHECK COMBINATION METER SYSTEM |
The circuits that send vehicle speed signals to this system are inspected in the meter system (Click here).
During inspection for the meter section, if there is an instruction that indicates to go back inspections for each system, proceed to the next step.
| NEXT | |
| 2. CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - COMBINATION METER) |
Disconnect the windshield wiper relay assembly connector E26 and combination meter connector F2.

Measure the resistance according to the value(s) in the table below.
- Standard resistance:
Tester Connection
Condition
Specified Condition
E26-19 (SPD) - F2-12 (+S)
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
| 3. CHECK HARNESS AND CONNECTOR (WINDSHIELD WIPER RELAY ASSEMBLY - NO. 3 J/B) |
Disconnect the 3P and 3J No. 3 J/B connectors.
Measure the resistance according to the value(s) in the table below.


- Standard resistance:
Tester Connection
Condition
Specified Condition
3J-9 - E26-19 (SPD)
Always
Below 1 Ω
|
|
||||
| OK | ||
| ||
