2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

Speed Signal Circuit

Circuit diagnosis · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The clock assembly receives the vehicle speed signal from the combination meter.

HINT:
  1. A voltage of 12 V or 5 V is output from each ECU and then input to the combination meter. The signal is changed to a pulse signal at the transistor in the combination meter. Each ECU controls the respective system based on the pulse signal.
  2. If a short occurs in any of the ECUs or in the wire harness connected to an ECU, all systems in the diagram below will not operate normally.


WIRING DIAGRAM

E211339E01

INSPECTION PROCEDURE


1. CHECK COMBINATION METER SYSTEM
  1. The circuits that send vehicle speed signals to this system are inspected in the meter system (Click here).

  1. During inspection for the meter section, if there is an instruction that indicates to go back inspections for each system, proceed to the next step.


NEXT


2. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - COMBINATION METER)

  1. E136599E02
    Disconnect the F2 and F3 connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    F3-9 (SPD) - F2-12 (+S)
    Always
    Below 1 Ω



NG
Go to step 3
OK

REPLACE CLOCK ASSEMBLY

3. CHECK HARNESS AND CONNECTOR (CLOCK ASSEMBLY - NO. 3 JUNCTION BLOCK)
  1. Disconnect the A No. 3 junction block connector.

  1. Measure the resistance according to the value(s) in the table below.E136598E02

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    3T-10 - F3-9 (SPD)
    Always
    Below 1 Ω



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR (CLOCK ASSEMBLY - NO. 3 JUNCTION BLOCK)
OK

REPAIR OR REPLACE HARNESS OR CONNECTOR (NO. 3 JUNCTION BLOCK)


← Speed Signal Circuit (Oct 2006 – May 2009)Power Source Circuit (from Oct 2006) →