2006-2011 Camry Aurion · Service Manual COMMUNICATION SYSTEM

DATA LIST / ACTIVE TEST

System information · Vehicles built Jun 2006 – Sep 2006

Versions by build date: Jun 2006 – Sep 2006 from Oct 2006


READ DATA LIST

HINT:
Using the intelligent tester to read the Data List allows values or status of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

  1. Warm up the engine.

  2. Turn the ignition switch to the OFF position.

  3. Connect the intelligent tester to the DLC3.

  4. Turn the ignition switch to the ON position.

  5. Turn the tester on.

  6. Enter the following menus: Diagnosis / Body / Main body / Data list.

  7. Read the Data List according to the display on the tester.

    Main Body ECU 
    Tester Display
    Measurement Item/Range
    Normal Condition
    Diagnostic Note
    Communication D-Door Motor
    Connection status between power window regulator motor (Driver side) and main body ECU (Instrument panel junction block assembly) / OK or STOP
    OK: Connection
    STOP: No connection
    DTC is output if an error occurs in LIN communication
    Communication Sliding Roof*
    Connection status between sliding roof ECU (Sliding roof drive gear) and main body ECU (Instrument panel junction block assembly) / OK or STOP
    OK: Connection
    STOP: No connection
    DTC is output if an error occurs in LIN communication

    HINT:
    *: Models with Sliding Roof System

← DTC CHECK / CLEAR (from Oct 2006)DATA LIST / ACTIVE TEST (from Oct 2006) →