PRECAUTION
Precautions · Vehicles built from Oct 2006
| 1.PRECAUTION |
Before performing any service operation or other procedure described in this Repair Manual, read the INTRODUCTION section.
Disconnect the negative battery cable before removing any system component.
Never start the engine without the battery connected correctly.
Never disconnect the battery while the engine is running.
When charging the battery, disconnect it from the vehicle's electrical system.
Never subject the mayday ECU to temperatures above 80 degrees C; for instance in a paint oven. Always remove the mayday ECU first, if this temperature is to be exceeded.
Ensure that all wiring harness plugs are connected firmly and the battery terminals are thoroughly clean.
The wiring harness connectors are designed to fit one way. Forcing the connectors into place is not necessary if it is being installed in the correct orientation. Failure to take care to match the indexing tabs and slots correctly can cause damage to the connector, the mayday ECU, or other vehicle components or systems.
Never connect or disconnect the mayday ECU wiring harness connectors when the ignition is switched ON.
Before performing any electric welding on the vehicle, disconnect the battery leads and the mayday ECU connectors.
Use only test equipment specified in the diagnostic charts. Using other test equipment may give incorrect results or damage good components.
All voltage measurements must be made with a digital voltmeter with an internal impedance rating of at least 10 million ohms per volt (10 meg ohms).
When a test light is specified, a low-power test light must be used. Do not use a high-wattage test light. While a particular brand of test light is not suggested, the following test on any test light will ensure it to be suitable for circuit testing.
Connect an accurate ammeter (such as the highimpedance digital multimeter) in series with the test light being tested.
Power the test light - ammeter circuit with the vehicle battery.
- If the ammeter indicates less than 300 mA, the test light is OK to use.
- If the ammeter indicates more than 300 mA, the test light is not OK to use.
- If the ammeter indicates less than 300 mA, the test light is OK to use.