OPERATION CHECK
Troubleshooting · Vehicles built from Oct 2006
| TOYOTA LINK SYSTEM TEST |
TURN THE ENGINE SWITCH ON (IG)
USE THE TDT
Select: System Menu / Diagnosis / Data List.
Scroll to Time of Last Known GPS Fix.
Check that the Time of Last Known GPS Fix is current.
Scroll to GSM Signal Strength, note the current GSM signal strength.
Position the vehicle where the Time of Last Known GPS Fix display is updating and the GSM Signal Strength is greater than 90 dbm.
Select: System Menu / Mode / Select Mode.
Program the mayday ECU into Active mode.
Disconnect the TDT from the vehicle.
PRESS THE TOYOTA LINK BUTTON
When the call is answered, identify yourself and your retail outlet and request a Toyota Link mayday ECU System Test.
(i.e. "Hello, this is Robert Smith from Jonestown Toyota, could you please carry out a Toyota mayday ECU System Test").The Toyota Link operator will then carry out a Toyota Link mayday ECU system test. During the test the operator will inform you that you have pressed the Toyota Link button and they have received a vehicle location.
Depending on the current Toyota Link mayday ECU system status, the operator will be able to either remotely unlock the doors or enable the mayday ECU Service mode. The operator will inform you which functions they are going to perform.
- If they are going to perform a Remote unlock, go to step (4).
- If they are going to enable Service mode go to step (5).
- If they are going to perform a Remote unlock, go to step (4).
Lower the driver's window. Close and lock all doors. The operator will then send a remote unlock request. The doors should then unlock within 30 seconds (this time to unlock will vary depending on SMS traffic). On receiving a verification message that the doors have unlocked, the operator will inform you that the system has passed the Toyota Link mayday ECU test. Thank the Toyota Link operator. Press the End Call button to end the call.
The operator will send a remote request to enable Service mode. On receiving a verification message that Service mode has been enabled, the operator will inform you that that the system has passed the Toyota Link mayday ECU test. Thank the Toyota Link operator. Press the End call button to end the call.
From the TDT select: System Menu / Select Mode / Select Mode. The operating mode should display Service.
Program the mayday ECU into Active Mode.
PRESS THE EMERGENCY BUTTON
When the call is answered, identify yourself and your retail outlet and request a Toyota Link mayday ECU system test.
(i.e. "Hello, this is Robert Smith from Jonestown Toyota, could you please carry out a Toyota Link mayday ECU system test").The Toyota Link operator will then carry out a Toyota Link mayday ECU system test. During the test the operator will inform you that you have pressed the emergency button and they have received a vehicle location. The operator will then end the call.