The mayday ECU monitors the ignition signal via CAN Bus, and the centre airbag sensor assembly on terminal GSW. If the mayday ECU is able to monitor the ignition signal and the centre airbag sensor signal successfully, the supplemental restraint system (SRS) is considered healthy. If the mayday ECU is unable to monitor the centre airbag sensor signal, but can monitor the ignition signal successfully, the SRS is considered unhealthy. DTC TL3 is set if the mayday ECU monitors the airbag signal as not in a healthy or deployed state while the engine switch is on (IG). This will be considered by the mayday ECU as an airbag unhealthy or airbag fault. When the start-up self test runs and fails, the mayday ECU stores the DTC and activates the red status LED.