2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TL5 Ignition Fault

Diagnostic trouble codes · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The mayday ECU monitors the ignition signal via CAN Bus, and the centre airbag sensor assembly on terminal GSW. The mayday ECU will monitor the ignition signal, sixty seconds after the engine switch is turned off.
If the mayday ECU monitors an OFF signal from the centre airbag sensor but the ignition signal is present, the mayday ECU then considers the supplemental restraint system (SRS) healthy but assumes a possible ignition fault.
DTC TL5 is set if the mayday ECU monitors the centre airbag sensor signal as active while the engine switch is off.

INSPECTION PROCEDURE


1. CHECK TDT DISPLAY
  1. Turn the engine switch on (IG).

  1. Select Diagnosis / Data List / Refresh.

  1. Scroll to display the ignition status.

    OK:
    Ignition ON



OK
Go to step 3
NG


2. CHECK MAIN POWER CIRCUIT
  1. Check the IGN fuse for continuity.

  1. Check the IG2 fuse for continuity.

  1. Check the IG2 relay for correct operation.

    OK:
    Continuity or correct operation



NG
REPLACE THE FUSE OR RELAY
OK


3. CONFIRM CAN OPERATION
  1. Is DTC TL4, CAN Communications Failure also set?



YES
DIAGNOSE THE CAN BUS SYSTEM (w/ Smart Entry and Start System) (Click here)
NO

REPLACE MAYDAY ECU


← TL5 Ignition Fault (Oct 2006 – May 2009)TL6 GPS Module Failure (from Oct 2006) →