2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TL11 Diagnostic Power Too High

Diagnostic trouble codes · Vehicles built from Oct 2006

DESCRIPTION

Supply voltage is applied to the mayday ECU diagnostic connector at all times via terminal 3.

INSPECTION PROCEDURE


1. CHECK DTCs
  1. Turn the engine switch on (IG).

  1. Select: Diagnosis / DTC List / Current DTC / Clear Current DTCs.

  1. Select: Back / History DTC / Clear Current DTCs.

  1. Start the engine and increase the engine speed to 1000 rpm for at least 1 minute.

  1. Does DTC TL11 reappear?



NO
CHECK CHARGING SYSTEM FOR AN INTERMITTENT FAULT (Click here)
YES


2. CHECK BATTERY VOLTAGE
  1. Turn the engine switch on (IG).

  1. Select: Systems Menu / Diagnosis / Data List.

  1. Scroll to the Battery Voltage.

  1. Start the engine and increase the engine speed to 1000 rpm for at least 1 minute.

  1. Read the voltage display.

    OK:
    16 V or less



NG
CHECK CHARGING SYSTEM FOR AN INTERMITTENT FAULT (Click here)
OK


3. CHECK MAYDAY ECU WIRE HARNESS

  1. B169478E01
    Disconnect the mayday ECU connectors A and B.

  1. Check for continuity between the mayday ECU unit connector N46 and connectors A and B.

    OK:
    Less than 1 Ω



NG
REPAIR OR REPLACE MAYDAY ECU WIRE HARNESS
OK


4. CHECK MAYDAY ECU CONNECTORS
  1. Are the mayday ECU connectors tight?



NO
REPAIR OR REPLACE THE CONNECTORS
YES

REPLACE MAYDAY ECU


← DIAGNOSTIC TROUBLE CODE CHART (from Jun 2009)TL12 Back-up Battery Timer Expired (from Oct 2006) →