2006-2011 Camry Aurion · Service Manual BODY ELECTRICAL

TL17 Microphone Circuit Short To Ground

Diagnostic trouble codes · Vehicles built from Jun 2009

Versions by build date: Oct 2006 – May 2009 from Jun 2009

DESCRIPTION

The active microphone in the roof console box provides a means for two-way voice communication between the vehicle occupants and Toyota Link Call Centre. During the system self test, the microphone and circuit are tested to determine if there is a microphone or microphone circuit malfunction.
DTC TL17 is set if the microphone circuit input voltage is less than 4.09 V.

INSPECTION PROCEDURE


1. CHECK DTCs
  1. Turn the engine switch on (IG).

  1. Select: Diagnosis / DTC List / Current DTC / Clear Current DTCs.

  1. Select: Back / History DTC / Clear Current DTCs.

  1. Turn the engine switch off for 1 minute, then on (IG) again.

  1. Is DTC TL17 reset?



NO
THE PROBLEM IS INTERMITTENT, CHECK THE MAYDAY ECU, WIRE HARNESS AND CONNECTORS
YES


2. CHECK ROOF CONSOLE BOX VOLTAGE

  1. B169481E01
    Disconnect the roof console box connector Q16.

  1. Turn the engine switch on (IG).

  1. Connect a digital multimeter between terminal 4 and ground and check for voltage.

    Standard:
    Less than 5 V


    Result:
    Result
    Proceed to
    Does the voltage meet specified value?
    A
    Is the voltage less than specified?
    B



A
Go to step 4
B


3. CHECK FOR SHORT TO GROUND

  1. B169481E01
    Turn the engine switch on (IG).

  1. With the roof console box connector still disconnected, check for voltage at terminal 10.

    OK:
    5 V



NG
Go to step 7
OK

REPAIR THE OPEN OR SHORT TO GROUND

4. CHECK ROOF CONSOLE BOX WIRE HARNESS.

  1. B169482E01
    Check for continuity between roof console box connector Q16 terminal 10 and mayday ECU unit connector N46 terminal 18.

    OK:
    Less than 1 Ω



NG
REPAIR OPEN CIRCUIT
OK


5. CHECK ROOF CONSOLE BOX CONNECTOR RETENTION
  1. Is the roof console box connector tight?



NO
REPAIR OR REPLACE THE CONNECTORS
YES


6. REPLACE ROOF CONSOLE BOX
  1. Clear all DTCs (Click here), and then verify operation.


NEXT

END

7. CHECK MAYDAY ECU WIRE HARNESS

  1. B169478E01
    Disconnect the mayday ECU connectors A and B.

  1. Check for continuity between the mayday ECU unit connector N46 and connectors A and B.

    OK:
    Less than 1 Ω



NG
REPAIR OR REPLACE MAYDAY ECU WIRE HARNESS
OK


8. CHECK MAYDAY ECU CONNECTORS
  1. Are the mayday ECU connectors tight?



NO
REPAIR OR REPLACE THE CONNECTORS
YES

REPLACE MAYDAY ECU


← TL17 Microphone Circuit Short To Ground (Oct 2006 – May 2009)TL18 Microphone Circuit Short To Battery (Oct 2006 – May 2009) →